The 2014-2016 Infiniti Q50 was the replacement for Nissan’s luxury subsidiary’s previous compact sports sedan, the Infiniti G37. The name of the model was changed to fit into the brand’s new nomenclature. With the new name came new body styling and a reworked chassis. The drivetrain was mostly a carry-over from the previous G37: the 3.7L VQ37HR V-6 producing 328 horsepower and 269 lb-ft of torque.
The AEM Intake Kit for 2014-2016 Infiniti Q50 provides two seperate intakes each with filter
If that’s not enough power for you, and really, when is it ever, AEM has the solution you seek.
The AEM 21-774DS performance air intake system is a free-flowing, induction system designed to replace the restrictive factory air filter and air intake tubing on 2014 – 2016 3.7L V6 Infiniti Q50 models. The intake system consists of two roto-molded plastic intake tubes, two precision dimensioned steel heat shields, and two conical AEM Dryflow air filters.
One key to the performance of the AEM 21-774DS air intake system is the Dryflow air filters made of non-woven synthetic filter media, a modern solution for controlling the quality of air that passes through it. Each 5.5-inch AEM 21-202DOSK conical filter helps protect your engine from harmful road grit, and both are mounted right at the front of the car where each can take full advantage of the cool incoming air, protected by a heat shield to keep underhood air out of the engine intake air.
The precision dimensioned heat shields seal tight to the factory pressurized air feed to channel fresh air to the air filters, located in the original air box spaces, which results in consistent power gains throughout the RPM range. This air intake system was also developed to accommodate the engine’s factory emissions control devices including the mass air flow sensors and crankcase vent tube.
AEM Dryflow Filters provide excellent filtration, long service, and easy cleaning with filter oil
If the shortest, most efficient path between two points is a straight line, it makes you wonder what automotive engineers had in mind when they design intake air ducting. A duct with twists and turns creates turbulent air and turbulent air doesn’t flow or mix with fuel as well. A duct with minimal bends, on the other hand, allows for the smooth flow of air and thus a greater volume of air reaches the engine and helps to mix with the atomized fuel. That’s the concept behind the AEM 21-774DS for your 2014 – 2016 3.7L V6 Infiniti Q50.
Noting the opportunity, AEM engineers developed the 21-774DS cold air intake, which they tuned and dyno-tested to improve acceleration and add a nice raspy engine sound. Installation is a relatively easy process, adding an estimated 10 horsepower and nearly 13 ft-lb of torque to your Q50. The performance increases can be easily achieved with a DIY installation that takes around 90 minutes or less with tools found in most garages.
The AEM 21-774DS air intake systems come with the necessary boots, clamps, and hardware for an OEM-type appearance. The kit also accommodates all factory emissions and vacuum lines. Existing mounting points are used for simple installation.
Your AEM 21-774DS is good for around 100,000 miles (depending upon your driving conditions) between cleanings. Clean-up is easy with an application of AEM 1-1000 synthetic air filter cleaner that loosens and dissolves dirt and grime build up on synthetic filters. Then you simply rinse the unit with water and reinstall.
Installation is straightforward and the filters unobtrusive under the hood
The 21-774DS is backed by AEM's Lifetime Limited Warranty.
The AEM 21-774DS is designed to fit the following vehicles:
2016 INFINITI Q50 3.7L V6 Fuel Injection - All Models
2015 INFINITI Q50 3.7L V6 Fuel Injection - All Models
2014 INFINITI Q50 3.7L V6 Fuel Injection - All Models