2015-2018 Hyundai Sonata 2.4L Air Intake Installation - #21-848C



Video - cold air intake system Installation for 2015-2018 Hyundai Sonata 2.4L, AEM #21-848C Watch how quick and easy it is to install the AEM 21-848C cold air intake system System for the 2015-2018 Hyundai Sonata with a 2.4L engine. This intake system includes an aerodynamic mandrel-bent aluminum intake tube, large open element AEM DRYFLOW® synthethic air filter, and a custom heat shield to help protect intake air from engine heat. Increasing airflow will help improve acceleration, horsepower, and engine sound. Add an estimated 4.4 horsepower at 6004 RPM and 10.1 lb-ft of additional torque at 3989 RPM to your 2015-2018 Hyundai Sonata 2.4L with the AEM air intake 21-848C.

TRANSCRIPT:

0:14
1. Turn off the ignition and disconnect the negative battery cable

0:19
2. Lift off the decorative engine cover

0:25
Remove the fresh air intake duct from the factory air filter housing and core support.

0:31
3. Disconnect the breather hoses from the factory intake atube and intake plenum

0:46
4. Loosen the hose clamps that secure the factory intake tube

1:07
and then remove the intake tube from the vehicle

1:13
5. Remove the two bolts that secure the factory air filter housing

1:34
and then remove the factory housing from the vehicle

1:38
6. Install the provided coupler hose (08711) onto the throttle body and secure with the provided hose clamp

1:50
7. Install the two-provided rubber mounted studs into the factory air filter housing mounting locations

2:10
8. Install the provided mounting stud onto the heat shield as shown

2:28
Install the provided edge trim into the hole of the heat shield as shown

2:54
9. Install the heat shield into the vehicle so the mounting stud inserts into the mounting grommet

3:05
then secure with the provided hardware

3:27
10. Install the provided vent lines and fittings onto the AEM® intake tube as shown

4:16
11. Install the AEM® intake tube into the heat shield and into the coupler at the throttle body

4:36
adjust the tube for best fit and then secure with the provided hose clamp

4:50
12. Install the AEM® air filter onto the intake tube and secure with the provided hose clamp

5:01
13. Install the AEM® badge into the heat shield cover and secure with the provided hardware

6:00
14. Install the cover onto the heat shield and secure with the provided hardware

6:50
Connect the factory vent lines to the lines installed onto the AEM® intake tube

7:16
Reinstall the fresh air intake duct from the factory air filter housing

7:23
Reinstall the decorative engine cover

7:28
Perform a final inspection before driving the vehicle
More Information on Part 21-848C


List of all AEM Product and Racing Videos
List of all Cold Air Intake Installation Videos