2012-2017 Toyota Camry 2.5L Air Intake Installation - #21-843C



Video - Short Ram Intake Installation for 2012-2017 Toyota Camry 2.5L, AEM #21-843C Watch how quick and easy it is to install the AEM 21-843C short ram intake system for the 2012-2017 Toyota Camry with a 2.5 liter engine. This short ram intake includes a mandrel bent aluminum intake tube, large open element AEM Dryflow air filter, and a custom steel heat shield. Increasing airflow will help improve acceleration, drivability, and give your Camry a sportier engine sound. Add an estimated 7.8 hp at 5,491 RPM and 4.7 lb-ft of additional torque at 3,145 RPM to your 2012-2017 Toyota Camry 2.5L with AEM air intake 21-843C.
TRANSCRIPT:
0:15 1. Turn off the ignition and disconnect the negative battery cable

0:21
2. Disconnect the mass air sensor electrical connection and unhook the wiring harness from the air box

0:30
3. Release the spring clamp and then disconnect the crank case vent hose from the fitting

0:38
4. Loosen the hose clamp securing the intake hose to the throttle body

0:45
5. Loosen the hose clamp and disconnect the engine sound tube from the engine sound drum

0:55
6. Remove the two bolts shown securing the resonator and air box to the core support

1:16
7. Remove the remaining air box mounting bolt

1:26
then lift up the air box assembly and remove it from the vehicle

1:35
8. Install the provided heat shield mounting bracket (070026) onto the lower air box mount using the factory bolt

2:04
9. Install the provided coupling hose (08186) onto the throttle body and secure with the provided hose clamp

2:18
10. Install the provided heat shield insulation strips onto the bottom of the heat shield as shown

2:45
Some trimming of the insulation strips excess will be necessary

2:50
11. Install the provided “L” bracket (083170) onto the heat shield using the provided hardware

2:57
Install the provided “L” bracket (070066) onto the heat shield using the provided hardware.

3:31 12. Install the provided “L” bracket (070015) onto the heat shield using the provided spacer

4:02
13. Cut the provided edge trim into two sections, one section is to be 27” long and the other section is to be 18” long

4:07
14. Install the 18” long section of edge trim into the hole of the heat shield as shown

4:22
and then install the 27” long section of edge trim onto the top of the heat shield as shown

4:42
15. Remove the core support bolt shown

4:51
16. Set the heat shield into position on the core support

5:14
and secure with the factory air box mounting bolts and to the previously installed bracket with the hardware provided

5:23
17. Remove the mass air sensor from the factory air filter housing

5:35
and then install it into the AEM® intake tube using the provided hardware

6:00
Install the provided 90º vent fitting into the AEM® intake tube as shown

6:15
18. Install the tube through the heat shield and then install the provided rubber mounted stud onto the tube as shown

6:39
Rotate the tube down and install it into the coupling hose on the throttle body and install the mounting stud into the bracket

6:57
Secure the tube with the provided hose clamps and hardware and tighten the mounting bracket at this time

7:11
20. Reconnect the mass air sensor electrical connection

7:16
Connect the crank case vent to the fitting installed into the AEM® intake tube as shown

7:24
21. Install the provided caplug onto the sound drum

7:28
21. Install the provided caplug onto the sound drum

7:38
Perform a final inspection before driving the vehicle
More Information on Part 21-843C


List of all AEM Product and Racing Videos
List of all Cold Air Intake Installation Videos